PREPARATION AND IDENTIFICATION OF NANOSIZED NICKEL OXIDE AND ITS USE IN REMOVING CRYSTAL VIOLET DYE IN AQUEOUS SOLUTION

Authors
  • Ghufran Khalid Hameed Sweed

    University of Anbar, College of Science, Department of Chemistry
  • Asmaa Lbrahim Salih Khayer

    University of Mosul College of Science Department of Chemistry
  • Salam Abdul Wahab Hamid Abdul Hussain

    University of Al_Qadisiyah College of Science Department of Chemistry
  • Dawood Salim Mohammed Hussein

    University of Samarra College of Applied Sciences Department of Applied Chemistry
Abstract

The catalyst was prepared by taking nickel chloride hexahydrate and dissolving it with oxalic acid. Adding it drop by drop for an hour, the precipitate was burned and dried, and thus nickel oxide was prepared in powder form, which is used to remove the (Methyl green) dye from the water surface by adsorption method. The best concentration of the (Methyl green) dye was studied and a calibration curve was made for the group of concentrations (0.001, 0.005, 0.007, 0.008, 0.01). It was found that (0.01 g) is the best concentration of the dye at a wavelength of λmax=695. The best weight of the catalyst was found and how it affected the dye. Also, the calibration curve was made for the group of concentrations (0.01, 0.1, 0.15) where it was shown that the concentration (0.15g) is also the best weight for the catalyst and the effect of temperature on the adsorption process was studied as the adsorption process is considered to be a heat generator and therefore it is inversely proportional to the temperatures (25C_35C_45C). Keywords: (Nickel chloride hexahydrate_ Preparation of nickel oxide in powder form_ Adsorption process_ Nickel chloride hexahydrate and its dissolution with oxalic_ Removal of (Methyl green) dye on a water surface).

References

1. Kuka, S., Hurbánková, M., Drlicková, M., Baska, T., Hudecková, H., & Tatarková, Z. (2016). Nanomaterials-a new and former public health issue. The case of Slovakia. Central European journal of public health, 24(4), 308..

2. Dobson, J. (2006). Magnetic nanoparticles for drug delivery. Drug development research, 67(1), 55-60.

3. Hurley, W. G., Wolfle, W. H., & Breslin, J. G. (1998). Optimized transformer design: inclusive of high-frequency effects. IEEE transactions on power electronics, 13(4), 651-659.

4. Haghi, A. K., Thomas, S., MirMahaleh, M. M., Rafiei, S., Maghsoodlou, S., & Afzali, A. (2019). Foundations of Nanotechnology-Three Volume Set. Apple Academic Press.

5. Edward, L. (2004). Wolf "Nanophysics and Nanotechnology", first ed., Wiley-VCH ISBN-13: 978-3527404070.

6. D. Vollath, "Nanomaterials an introduction to synthesis, properties and application," Environ. Eng. Manag. J., vol. 7, no. 6, pp. 865-870, 2008.

7. N. Abid et al., "Synthesis of nanomaterials using various top-down and bottom-up approaches, influencing factors, advantages, anddisadvantages: A review," Adv. Colloid Interface Sci., vol. 300, р. 102597, 2022.

8. C. Liu and Z. J. Zhang, "Size-dependent superparamagnetic properties of Mn spinel ferrite nanoparticles synthesized from reverse micelles," Chem Mater., vol. 13, no. 6, pp. 2092-2096, 2001.

9. Ahmed J. Hassan, (2014) " Study of optical and electrical properties of nickel oxide (NiO) thin films deposited by using a spray pyrolysis technique", Journal of Modern Physics. 5,2184-2191.

10. S.Benhamida, (2018) Caracterization of Minces of Nickel Oxide (NiO)Elaboration by Spray Pyrolysis",Doctoral Thesis, Biskra University, Algeria.

11. Praddyot. Patnaik, Hand book of Inorganic Chemicals, 2002

12. Mr.Mebrouk GHOUGALI, "Elaboration and Characterization of nanostructuring NiO thin films for Gas Sensing Application Doctorate Of Science in Physics, University Of Mohamed Khider, Biskra, 2019

13. P.D.Hoon, "Optimization of nickel oxide -based electrochromic thin films ",Doctoral Thesis, Bordeaux 1 University, (2010), France

14. Department of Health, Public Health Service .ATSDR. Toxicological Profile for Nickel. Atlanta, GA, USA:US(2005)

15. Patnaik, P. (2003). Handbook of inorganic chemicals (Vol. 529). New York: McGraw-Hill.

16. Patil, V. P., Pawar, S., Chougule, M., Godse, P., Sakhare, R., Sen, S., & Joshi, P. (2011). Effect of annealing on structural, morphological, electrical and optical studies of nickel oxide thin films. Journal of Surface Engineered Materials and Advanced Technology, 1(02), 35.

17. Salvadori, M. R., Nascimento, C. A. O., & Corrêa, B. (2014). Nickel oxide nanoparticles film produced by dead biomass of filamentous fungus. Scientific reports, 4, 6404.

18. Hyeon, T. (2003). Chemical synthesis of magnetic nanoparticles. Chemical Communications, (8), 927-934.

19. Karmhag, R., Tesfamichael, T., Wäckelgård, E., Niklasson, G. A., & Nygren, M. (2000). Oxidation kinetics of nickel particles: comparison between free particles and particles in an oxide matrix. Solar Energy, 68(4), 329-333.

20. Ezhilarasi, A. A., Vijaya, J. J., Kaviyarasu, K., Maaza, M., Ayeshamariam, A., & Kennedy, L. J. (2016). Green synthesis of NiO nanoparticles using Moringa oleifera extract and their biomedical applications: Cytotoxicity effect of nanoparticles against HT-29 cancer cells. Journal of Photochemistry and Photobiology B: Biology, 164, 352-360.